[ NETWORKED / SWITCHED RACK PDU // EXACT SKU ]
CyberPower PDU41023 Switched PDU
120 V single-phase, L5-30P 30 A input (24 A continuous), 16 switched NEMA 5-20R outlets; 1U. This static record covers the named model only; confirm complete regional suffix, revision and nameplate before installation.
ARCHIVAL IDENTIFICATION: PDU41023. Record the complete label, serial/date code, firmware and condition; similarly named models are not electrically interchangeable.
Exact model specifications
| SKU / topology | PDU41023 — networked switched rack power distribution unit; no UPS battery or stored runtime. |
|---|---|
| Input and output voltage | 100–120 V AC input; 100–120 V AC output |
| Phase / ampacity | Single phase; 30 A input, 24 A maximum continuous load (80% derating) |
| Outlet count and type | 16 × NEMA 5-20R (eight front, eight rear); individually switched |
| Metering / outlet switching | Input voltage/current/power metering at the LCD and over the management interface; individual or grouped outlet switching. |
| Network management | RJ45 Ethernet network management; web/SNMP access and event alerts supported by the installed management firmware. |
| Rack dimensions | 1U horizontal rackmount; approximately 17.1 × 8.5 × 1.8 in (W×D×H), 19-inch rack compatible. |
| Plug and load compatibility | Attached NEMA L5-30P twist-lock plug. Requires a matching grounded 120 V single-phase L5-30R branch receptacle and circuit; NEMA 5-20R outputs accept 5-15P/5-20P loads only within branch and per-outlet ratings. |
| Electrical safety | 30 A inlet does not mean 30 A continuous load: limit continuous load to 24 A and follow branch-breaker and outlet-bank limits. Maintain protective earth, do not use improvised adapters, and check the product label and local electrical code before installation. |
Service and safe deployment
- Verify voltage, phase, inlet plug, circuit ampacity, continuous load and per-outlet ratings against the PDU nameplate and the exact product manual.
- Use grounded, correctly protected service; never defeat the protective-earth conductor, overload an outlet/bank, or daisy-chain power strips/PDUs.
- Mount the chassis using the manufacturer-approved brackets and preserve ventilation and strain relief. Inspect cord, plugs, receptacles and enclosure for heat, wear or damage.
- Disconnect upstream power before installation, relocation or service. Do not open energized mains equipment; use a qualified electrician where required.
- Network management can switch power to connected systems; isolate management access, set unique credentials and verify firmware before deployment.
Manufacturer sources and manual
- Manufacturer product page — CyberPower PDU41023 Switched PDUManufacturer model listing and configuration details; match the complete SKU and region.
- Manufacturer documentation — PDU41023 User ManualManufacturer manual, technical data or specifications; use the revision applicable to the unit label and follow its installation and safety directions.