[ PCIE 4.0 NVME // IDENTIFIED PRODUCT ]
WD_BLACK SN850P 2 TB for PS5 (WDBBYV0020BNC-WRSN)
Product-specific catalog record for the manufacturer code below. Performance figures are manufacturer-rated values, not independent test results.
IDENTIFY THE EXACT SKU: Compare the full MPN, label suffix, form factor, firmware and any OEM/security code before applying these notes. Family variations, capacity changes and factory thermal assemblies can materially change ratings and compatibility.
Manufacturer-identified specifications
| Product / MPN | WD_BLACK SN850P 2 TB for PS5 (WDBBYV0020BNC-WRSN) — WDBBYV0020BNC-WRSN |
|---|---|
| Capacity / form factor | 2 TB; M.2 2280, factory heatsink, single-sided M.2 card. |
| Interface / lane width | PCIe 4.0 x4. |
| Protocol | NVMe. |
| Rated performance / endurance | Up to 7,300 MB/s sequential read (2 TB SKU); exact sequential write and endurance not repeated here because the linked product listing does not expose a capacity-specific line for both values. |
| Heatsink / revision caveat | Factory-installed heatsink on this PS5-branded SKU. Use the PS5 M.2 bay as specified; do not stack the console cover/spacer incorrectly or add another heatsink. This is the PS5-oriented SN850P, distinct from the existing SN850X and SN850P bare/other capacity SKUs. Sony PS5 console software and installation instructions determine console use; PC fit does not imply console clearance. Manufacturer/console compatibility applies to the exact MPN. |
Compatibility, installation & service
- Follow Sony’s PS5 M.2 storage installation guide and the SN850P product instructions for console firmware, slot screw/spacer, cover closure and minimum performance requirements. Power the console fully off before fitting. On PC, verify 2280 PCIe/NVMe support and heatsink clearance. Avoid removing the factory thermal solution and back up before service.
- This is the PS5-oriented SN850P, distinct from the existing SN850X and SN850P bare/other capacity SKUs. Sony PS5 console software and installation instructions determine console use; PC fit does not imply console clearance. Manufacturer/console compatibility applies to the exact MPN.
- Confirm host boot mode, OS NVMe support, CPU lane generation, socket length/keying, power and controller/backplane qualification from the system manual; physical fit alone does not establish compatibility.
- Before drive replacement, check backup integrity, encryption keys, firmware settings, recovery media and array rebuild plans. Use electrostatic-discharge precautions and never hot-remove unless the host documentation explicitly supports it.
Manufacturer references
- SanDisk / WD_BLACK SN850P 2 TB — exact manufacturer SKU pageManufacturer specification/product reference. Verify the precise SKU and its capacity-specific table, manual or linked downloads against the installed drive label.
- NVM Express — specificationsProtocol standards reference; it does not establish product-specific features or host boot support.
- PCI-SIG — PCI Express specificationsInterface generation/lanes standards reference, not a substitute for the host motherboard/server manual.
Manufacturer peak ratings reflect stated test conditions and may not represent sustained writes in a thermally constrained or cache-exhausted host. Confirm current regional support, service status and warranty terms before use.