[ PCIE 3.0 NVME DRIVES // IDENTIFIED PRODUCT ]
WD_BLACK SN750 1 TB
1 TB M.2 2280, bare module; PCIe 3.0 NVMe SSD. Cataloged by the complete manufacturer part number below; performance figures are vendor-rated, not independent test results.
IDENTIFICATION: Verify the complete MPN, suffix, serial/date code, hardware revision and firmware against the product label. Capacity variants, factory heatsinks and regional SKUs may differ; the link and rated data below apply only to the specified configuration where the manufacturer identifies it.
Manufacturer-identified specifications
| Product / MPN | WD_BLACK SN750 1 TB — WDS100T3X0C (bare-module SKU; compare full label suffix) |
|---|---|
| Capacity / form factor | 1 TB; M.2 2280, bare module. |
| Interface / lane width | PCIe 3.0 x4. |
| Protocol | NVMe 1.3. |
| Rated performance / endurance | Sequential up to 3,470 MB/s read and 3,000 MB/s write (1 TB SKU); 600 TBW endurance (1 TB SKU). |
| Model era | 2019 product generation; check manufacturer lifecycle/support notice. |
| Heatsink / revision | A bare module. SN750 was also sold in a factory-heatsink edition with a different SKU; the motherboard cover may not fit over that tall heatsink. |
Compatibility, installation & service
- Check the exact WDS100T3X0C suffix against the label; WDS100T3XHC is the distinct factory-heatsink family code. M.2 2280 shape does not imply NVMe support in a given socket. Boot support and lane sharing are board/UEFI-specific; PCIe 4/5 hosts may run this drive at Gen3 link speed.
- Read the host manual for M-key PCIe/NVMe signaling, 2280 mounting, bootable NVMe support, and any SATA-port or PCIe-lane sharing. Use either the board heatsink or compatible factory heatsink SKU, never force the cover against a tall module. Monitor SMART temperature under sustained writes; throttling depends on airflow and host cooling. Verify firmware and use WD Dashboard only where the specific drive remains supported; back up before updates or service.
- Do not hot-plug an M.2 module unless the server/platform manual explicitly documents hot-plug support. Shut down cleanly, disconnect standby power when instructed, and use electrostatic-discharge precautions during handling.
- Before replacing a boot drive, verify a recoverable backup, OS recovery media, encryption keys, firmware settings and the target system’s boot mode; physical fit does not establish compatibility.
Manufacturer references
- WD_BLACK SN750 — manufacturer 1 TB SKU specificationsOfficial manufacturer product/specification reference; use the exact MPN on the drive label and its linked specification/downloads for revisions, capacity ratings, fit and warranty limits.
- NVM Express — specifications and technical documentationStandards reference for NVMe; it does not establish this product’s SKU-specific implementation.
Manufacturer ratings are model/capacity-specific and measured under stated vendor conditions; they are not guarantees of sustained speed in every host. Confirm current datasheet/manual, support status and warranty in the manufacturer’s regional support portal before deployment.