[ PCIE 5.0 NVME DRIVES // IDENTIFIED PRODUCT ]
CORSAIR MP700 PRO 2 TB (CSSD-F2000GBMP700PRO)
2 TB M.2 2280, bare-module MP700 PRO SKU; PCIe 5.0 NVMe SSD. Cataloged by the complete manufacturer part number below; performance figures are vendor-rated, not independent test results.
IDENTIFICATION: Verify the complete MPN, suffix, serial/date code, hardware revision and firmware against the product label. Capacity variants, factory heatsinks and regional SKUs may differ; the link and rated data below apply only to the specified configuration where the manufacturer identifies it.
Manufacturer-identified specifications
| Product / MPN | CORSAIR MP700 PRO 2 TB (CSSD-F2000GBMP700PRO) — CSSD-F2000GBMP700PRO |
|---|---|
| Capacity / form factor | 2 TB; M.2 2280, bare-module MP700 PRO SKU. |
| Interface / lane width | PCIe 5.0 x4. |
| Protocol | NVMe 2.0. |
| Rated performance / endurance | Sequential up to 12,400 MB/s read and 11,800 MB/s write; 1,400 TBW endurance for 2 TB SKU. |
| Model era | 2023 product generation; check manufacturer lifecycle/support notice. |
| Heatsink / revision | This is the bare-module version; CORSAIR offers separately specified active-air and Hydro X cooling versions. Gen5 heat requires the cooling arrangement specified for the exact SKU; do not treat the bare part as an included-heatsink model. |
Compatibility, installation & service
- The 2 TB bare module is not interchangeable from a cooling perspective with MP700 PRO variants equipped with an active fan or liquid cold plate. Check the full SKU, host PCIe 5.0 x4 support, and thermal clearance. OS boot capability depends on motherboard firmware/UEFI and NVMe implementation.
- Follow the exact CORSAIR install guide and motherboard service manual for the selected cooling version, M.2 standoff, thermal interface, and airflow. Do not remove/modify factory cooling on variants that include it; avoid trapping a bare Gen5 SSD beneath an incompatible board cover. Confirm slot bandwidth/lane sharing and boot support, back up before firmware service, and monitor temperature in sustained workloads.
- Do not hot-plug an M.2 module unless the server/platform manual explicitly documents hot-plug support. Shut down cleanly, disconnect standby power when instructed, and use electrostatic-discharge precautions during handling.
- Before replacing a boot drive, verify a recoverable backup, OS recovery media, encryption keys, firmware settings and the target system’s boot mode; physical fit does not establish compatibility.
Manufacturer references
- CORSAIR MP700 PRO 2 TB — exact manufacturer SKU pageOfficial manufacturer product/specification reference; use the exact MPN on the drive label and its linked specification/downloads for revisions, capacity ratings, fit and warranty limits.
- NVM Express — specifications and technical documentationStandards reference for NVMe; it does not establish this product’s SKU-specific implementation.
Manufacturer ratings are model/capacity-specific and measured under stated vendor conditions; they are not guarantees of sustained speed in every host. Confirm current datasheet/manual, support status and warranty in the manufacturer’s regional support portal before deployment.